Marble and granite countertop processing, the procedure needs to pay attention to seven points

1. Purchasing requirements The width of the board is usually between 1.95-2.15cm:

2. The thickness from the purchased light board is 1.90-2.1cm as well as the gloss is over 85:

3, the big lower process notes:

(1) Blocks ought to be placed firmly and smoothly within the platform.

(2) Understand and see the large cut-off schematic diagram of the stone.

(3) The large-cut size correction and review before the lower knife ought to be careful and accurate.

(4) After cutting the initial three bits of the block, first stop and knock off the 1st Stone Tools & Machine; www.chitrust.com, skin to check on the grade of the block: whether a couple of any defects such as dark splits, color gall, stains, and color lines; If the thickness is within the allowable tolerance (20mm �� 5mm) and timely correction

(5) Machine inspection, maintenance cleaning and cleaning work should be done before and after operation.

(6) Complement: It is best to cut (height) together with thickened plates, especially for stone with grain.

4, the width of the process notes:

(1) The actual thickness after thickness setting is 19.5-2.0 cm. Use a vernier caliper to check the thickness.

(2) Be cautious when handling. Pay attention to safety and steer clear of damage to the sheet.

(3) Machine inspection, maintenance cleaning and cleaning work should be completed before and following operation.

5, large surface area polishing process notes:

(1) Please fill in the glue before polishing, fill in the gap between your stone dish (especially granite), and avoid waiting for the finished product to spend a lot of manpower around the aesthetic glue.

(2) The polishing process is performed by using a full set of resin abrasives.

(3) Gloss of 85 or even more.

(4) Take care to avoid inadvertent damage to the sheet when lifting the board.

(5) The corners should be floor and the gloss ought to be enough.

6, the bridge shear procedure notes:

(1) To cut the face up.

(2) The saw blade should be sharp. (The blade can be sharpened prior to the knife is cut)

(3) To regulate the lower knife and cutting speed.

(4) There has to be a machining allowance. (The remaining amount is usually 3-4mm, and the seam is defined to within 0.3mm when utilized for 1/2 round environment).

(5) If the natural stone with grain is usually to be cut out together with the thickened part, the texture of the huge surface as well as the thickened edge will be appropriate, as well as the finished product will be beautiful and natural.

(6) Avoid the trend of missing edges, missing edges, not completely cut, cutting, and wrong size.

(7) Machine inspection, maintenance, cleaning and cleaning work should be completed before and following operation.

7. Gluing and establishing process:

(1) To make the coloring carefully, make an effort to adjust the glue to the basic and stone color.

(2) The top plate and the dense plate ought to be as close as is possible. After the adhesion, repair the clip with iron and correct it to create it glue.

(3) Gluing using a sheet that's in contact with the anastomosis before gluing.

(4) The seam following gluing is not more than 0.3mm.

(5) When gluing, be careful to scrape the surplus glue when the glue continues to be dry, to avoid spending a lot of manpower in the glue through the cosmetic process.